Print it at 100 %, check the square, glue it in order
A tiled poster only lines up if every sheet comes out of the printer at exactly the size it was made. Here is how to make sure it does, and how to put the sheets together.
1. Print at "Actual size" or "100 %", not "Fit"
Home printers can't print to the very edge of the paper. Most print dialogs quietly fix that by shrinking every page a little ("Fit", "Shrink oversized pages", "Fit to printable area"), usually by 3–6 %. On one page you'd never notice. On a poster it means the sheets no longer meet, the overlaps don't match, and a pattern or plan comes out the wrong size.
Poster Tiler already keeps everything inside the margin you set, so nothing needs shrinking. Look for:
| Printing from | Setting |
|---|---|
| Adobe Acrobat / Acrobat Reader | Page Sizing & Handling → Actual size (not "Fit" or "Shrink oversized pages") |
| Chrome or Edge (PDF opened in the browser) | More settings → Scale → Actual size or Custom 100, not "Fit to printable area" |
| Preview on a Mac | Scale 100 %, with "Scale to Fit" off |
| Firefox | Scale 100, with "Fit to page width" off |
| Phone or tablet | Often no scale setting at all and it fits by default. Print from a computer if you can; otherwise measure the test square first. |
Also check the paper size in the print dialog matches the paper you made the PDF for (Letter vs A4 is the classic mix-up).
2. Check the test square before printing the rest
Print just page 2 first: it has a square that should measure 100 mm (3.94 in) on every side, and a 3-inch line. Sheet A1 also has a 50 mm check line in its top margin. If the square is 96 or 97 mm, the dialog is still set to fit; change it and print again. A millimetre either way is the printer itself and won't add up across sheets, because each sheet is lined up on the picture, not on the paper's edge.
3. Lay the sheets out with the map
Page 1 is the assembly map: the whole poster with every sheet's label on it. Rows are letters (A at the top), columns are numbers (1 on the left), so B3 is the second row, third sheet across. Every sheet's label and its neighbours are printed in its bottom margin.
4. Trim the left and top, overlap, glue
- Leave A1 as it is. On every other sheet, cut off the white margin along the cut line on its left edge (if it has a sheet to its left) and its top edge (if it has a sheet above).
- Work along row A: lay A2's trimmed left edge on A1's shaded strip, on the dashed line, so the picture continues across the join. Glue stick or tape on the shaded strip. Then A3 onto A2, and so on.
- Do each row the same way, then join the rows: row B's trimmed top edge goes over row A's bottom strip.
- Finally trim the outside to the thin grey line: that's the finished edge of the poster.
Glue stick, double-sided tape or a few pieces of clear tape on the front all work. For patterns you'll trace or cut fabric from, tape on the front so the sheets can't shift. Lining up a detail of the picture is more accurate than lining up paper edges.
Choosing the overlap
10 mm is a good default for glue. 0 mm makes sheets that meet edge to edge: trim all the margins and tape from the back (some sewing patterns are designed for that and have their own match marks). Up to 30 mm if your printer's margins vary from page to page.
How sharp will it be?
A PDF page stays sharp at any size: its lines and text go into the poster as they are. A photo has only so many pixels; the tool shows how many per inch you'll get on paper. 150 or more looks sharp in your hand, around 100 is fine on a wall, under 60 looks blocky up close.